The heat tape was then installed on the bottom of the compact refrigerator, beneath the crisper drawer, using foil tape. I then covered the connections with electrical tape for added safety. Next I connected the power cord to the flexwatt heat tape using the clips and insulators. I found mounting the temperature probe from the thermostat where the temperature probe from the refrigerator was originally located to be convenient for me. I put a little petroleum jelly on the wires to help them slide more easily. Things get a little tight here, so be patient and careful not to break any wires. Cutting the lines and removing the compressor should only be done by a qualified professional who can remove the refrigerant in a safe and legal manner.Īfter removing the shelving for better access, I ran the wires for the heat source and temperature probe through the drain hole near the back of the refrigerator. ![]() ![]() I did not remove the compressor from the refrigerator. I have also removed the excess wiring to the compressor and internal controls to clean things up. I then cut the wires and discarded the cord as it was no longer needed. I began by removing the clamp holding the power cord on the back on the refrigerator. 1 Pair Flexwatt – Clip Sets for Heat Tape.Digital Proportional Thermostat (recommended) or Pre-wired Johnson Controls Thermostat, Ranco ETC-111000.1 Prewired Helix DBS1000 Proportional Thermostat, Herpstat. ![]() I used the following to make this incubator: I highly recommend using a good quality thermostat as opposed to a rheostat for your temperature controller. This article is an example of how an incubator can be simply made by using an inoperable compact refrigerator.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |